Fret Slotting Mitre Jig

Stewmac, Fret Slot Depth Gauge Don't wait until after you've installed a fret to discover the slot wasn't quite deep enough! Dan Erlewine developed this

Later sanding? With frets installed? no- I slot, then glue the FB on, then sand level etc, then fret

fret slot depth I cut the slots straight on a table saw before cutting the radius I usually cut them about deep, then the radius reduces the depth on

fret slot width Be sure your fretwire will fit! Don't wait until after you've installed a fret to discover the slot wasn't quite deep enough! Not sure if your fret slots